TEKONSHA PRODIGY iD Manual De Instrucciones Y Operación página 4

CAUTION After removal of Red Dust Cap, DO NOT TOUCH THE
ELECTRICAL CONTACTS. THIS MAY DAMAGE THE DEVICE.
Align Display Assembly as shown with logo lettering oriented
upwards. Press inward until both snaps are engaged.
Align large snaps on Manual Knob with notches on Knob Base. Push
on until snaps are fully engaged. Remove lens protector.
Vehicle Wiring
WARNING
Inadequate grounding may cause intermittent
braking or lack sufficient voltage to trailer brakes and may result in
accidents.
1. The WHITE wire must be connected to a suitable ground location.
The negative terminal of the battery is a suitable ground location in
the absensce of a Trailer Tow Package connection.
2. Connect BLACK (+) wire through an automatic reset circuit breaker
20 amp for 1-2axles, 30 amp for 3-4 axles to the POSITVE (+)
terminal of the battery. The BLACK wire is the power supply line to
the brake control.
3. The RED (stop light) wire must be connected to the vehicle braking
circuit.
WARNING Do not disrupt the vehicle braking circuit. If you
are unsure of which wire to use, contact local vehicle dealer,
Tekonsha dealer or technical support.
4. The BLUE (brake output) wire must be connected to the trailer
connector's brake wire.
5. Connect the 4-Pin Universal Wire Harness to the Power Module.
6. Turn on the Vehicle's Ignition Switch.
- 12 en -
- 14 en -
Power Module Mounting
CAUTION The Power Module must be mounted in a suitable
location.
The Power Module can be mounted to any suitable surface with
Tie-Wraps or screws. Do Not mount to, or underneath the carpeting
which will not allow for proper module cooling.
Select a Location
Use (2) 14in Tie Wraps to mount
the Power Module to a suitable
surface.
Secure the excess wiring with
8in Tie-Wraps (provided).
Mounting bosses for
Tie-Wraps or screws
7. Rotate the Manual Override to verify that the Dash Module and
Display are illuminated. Display will Flash
connected, or when the trailer is connected.
Typical Wiring Diagram
Stoplight Switch
Connect to COLD SIDE
(Voltage Only When Pedal is Pushed)
20A or 30A Auto-Reset
Circuit Breaker (Not Supplied)
AUX
BATT
Chassis Ground
12 Volt Battery
- 13 en -
if the trailer is not
Brake
Control
Stoplight Red
Battery (+) Black
Ground (-) White
Brake Blue
Trailer
Connector
- 15 en -