Electrical Connection - EAS ELECTRIC EMWY86BI Manual De Instrucciones

SAFETY INSTRUCTIONS
Do not operate the machine in rooms with a tempe-

rature of below 5°C. This can cause damages to parts of
it. If it is unavoidable, make sure to drain the water
completely from the appliance after every use (see
"Maintenance - Cleaning of drain pump filter") to avoid
damages caused by frost.
 Never use flammable sprays or substances in the imme-
diate proximity of the appliance.
INSTALLATION
Remove all packaging material and transport bolts

before using the appliance. Otherwise, serious damage
may result.
 This appliance is equipped with a single inlet valve and
can be connected to the cold water supply only.
 Mains plug must be accessible after installation.
Before washing clothes for the first time, the product

shall be operated once throughout all the procedures
without any clothes inside.
Before using the washer dryer, the product shall be

calibrated.
Do not put any excessively heavy objects on the

appliance, like water containers or heating devices.
 The new hose-sets supplied with the appliance are to be
used and that old hose-sets should not be reused.
 Max. Inlet water pressure 1 MPa. Min. inlet water pressure
0.05 MPa.

ELECTRICAL CONNECTION

 Make sure the supply cable is not trapped by the ma-
chine, it can get damaged.
 Connect the product to a grounded outlet protected by
a fuse complying with the values in the " Technical
specifications" table. The grounding installation has to
be made by a qualified electrician. Ensure that the
machine is installed in accordance with the local
regulations.
5 V.1