Installation - EAS ELECTRIC EMWY86BI Manual De Instrucciones

INSTALLATION

Remove transport bolts
Warning!
！
You must remove the transport bolts from the backside before
using the product.
Loosen the 4
transport bolts
with a spanner.
Levelling the washer dryer
Warning!
！
The lock nuts on all four feet must be screwed tightly against
the housing.
Connect the water supply hose
Warning!
！
To prevent leakage or water damage, follow the instructions in
this chapter. Do not kink, crush or modify water inlet hose.
Note!
Connect manually, do not use tools. Check if the connections
are tight.
Remove the bolts
including the rubber
parts and keep them
for future use.
1. Loosen the lock nut.
2. Turn the foot until it reaches the
floor.
3. Adjust the legs and lock the nuts
with a spanner. Make sure the
machine is level and steady.
Connect the water
supply hose to the water
inlet valve and a water
tap with cold water as
indicated.
12
Close the holes
using the cover
caps.
V.1