Safety Instructions - LUND 68510 Manual Original

All manuals and user guides at all-guides.com
GB
DEVICE FEATURES
The espresso coff ee maker is used for brewing coff ee. The ground coff ee beans are placed in the special brewing fi lter in the
fi lter holder. The water from the coff ee maker tank is passed under high pressure through the ground coff ee beans and fl ows as a
beverage into a vessel placed under the fi lter holder spouts. The appliance also has a separate nozzle to froth the milk or to obtain
hot water. The appliance is intended for household use only. The correct, reliable, and safe operation of the appliance depends
on its proper use, therefore:
Read and keep the entire manual before the fi rst use of the appliance.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
specifi ed in this manual.
ACCESSORIES
The appliance is sold complete, but requires certain preliminary actions described in the further sections of the manual. The
coff ee maker equipment includes the fi lter holder, two brewing fi lters with diff erent capacity and a measuring spoon with a tamper.

SAFETY INSTRUCTIONS

WARNING! The appliance may heat up to a high temperature during operation. Be careful
when handling it.
Recommendations concerning transport and installation
The appliance may only be placed on a hard, fl at, level, non-fl ammable and resistant to high
temperatures surface. The surface should be able to withstand the weight of the appliance
itself and of the water it contains. Ensure that there is a minimum distance of 10 cm around
the side walls of the appliance, and do not place non-high temperature resistant materials
above the product. This will allow for the proper ventilation of the appliance. Do not place
near edges of, e.g. a table. Do not place anything on the appliance. This disrupts the air cir-
culation and can cause damage to the appliance as well as fi re. Do not place the appliance
near fl ammable materials, e.g. curtains or drapes. Do not place any electrical equipment
above the appliance. During operation, water vapour is released, which can cause a short
circuit in the electrical system and lead to electric shock. It is forbidden to drill any holes in
the appliance, as well as making any other modifi cations of the appliance not described in
the manual. Do not move the appliance by pulling on the power cord. The temperature at the
place of installation and use of the appliance must be within the range of +10 C ÷ +38 C,
O O
and the relative humidity must be below 90% without condensation.
Recommendations for connecting the product to the power supply
Before connecting the appliance to the power supply, make sure that the voltage, frequency
and performance of the power supply correspond to the values shown on the appliance's
rating plate. The plug must fi t into the socket. It is forbidden to modify the plug or socket in
any manner to make them fi t. The appliance must be connected directly to a single power
supply socket. It is forbidden to use extension cords, adapters or double sockets. The mains
circuit must be equipped with a protective cable and 16 A protection. Avoid contact between
the power cord and sharp edges and hot objects and surfaces. During operation, the power
cord must always be fully extended and the position of the power cord must be set so that
it does not become an obstacle during operation. The power cord should not be placed in
O R I G I N A L I N S T R U C T I O N S
12