Toshiba RAV-SM2242DT-E Manual De Instalación página 35

Concealed Duct High Static Pressure
8°C Operation
Pre-heating operation can be set for cold regions where room
temperature drops to below zero.
1
Procedure
Push simultaneously +
or more when the air conditioner is not working.
After a while, the display part flashes as shown below. Check
the Displayed CODE No. is [10].
• When the CODE No. is other than [10], push
erase the display and repeat procedure from the first step.
(After pushing button, operation of the remote
controller is not accepted for approx. 1 minute.)
(* Display changes according to
the model No. of indoor unit.)
2
Procedure
Every pushing button, the indoor unit No. in the
group control is displayed in order. Select the indoor unit of
which setup is changed. In this time, the position of the indoor
unit of which setup is changed can be confirmed because fan
of the selected indoor unit operate.
3
Procedure
Using TEMP. / buttons, specify CODE No. [d1].
4
Procedure
Using TIME / buttons, select SET DATA [0001].
SET DATA 8°C Operation setting
0000
0001 8°C Operation setting
5
Procedure
Push button.
In this time, the setup finishes when the display changes from
flashing to lighting.
6
Procedure
Push button.(Setup is determined.)
When pushing button, the display disappears and the
status
Becomes the usual stop status. (When pushing
the operation from the remote controller is not accepted for
approx. 1 minute.)
All manuals and user guides at all-guides.com
+ buttons for 4 seconds
button to
None
(Factory default)
button
– 34 –
Installation Manual
EN
34-EN