Power Saving Mode - Toshiba RAV-SM2242DT-E Manual De Instalación

Concealed Duct High Static Pressure
6
Procedure
When settings have been completed, push
determine the settings.
When button is pushed, "SETTING" flashes and then the
display content disappears and the air conditioner enters the
normal stop mode.
(While "SETTING" is flashing, no operation of the remote
controller is accepted.)
Filter sign setting
According to the installation condition, the filter sign term
(Notification of filter cleaning) can be changed.
Follow to the basic operation procedure
1 2 3 4
→ → → →
(
• For the CODE No. in Procedure
• For the [SET DATA] in Procedure
of filter sign term from the following table.
SET DATA
0000
0001
0002
0003
0004
To secure better effect of
heating
When it is difficult to obtain satisfactory heating due to
installation place of the indoor unit or structure of the room,
the detection temperature of heating can be raised. Also use
a circulator, etc. to circulate heat air near the ceiling.
Follow to the basic operation procedure
1 2 3 4
→ → → →
(
• For the CODE No. in Procedure
• For the set data in Procedure
shift value of detection temperature to be set up from the
table below.
SET DATA Detection temperature shift value
0000
0001
0002
0003
0004
0005
0006
29-EN
All manuals and user guides at all-guides.com
button to
5 6
→
).
3
, specify [01].
4
, select the SET DATA
Filter sign term
None
150H
2500H
(Factory default)
5000H
10000H
5 6
→
).
3
, specify [06].
4
, select the SET DATA of
No shift
+1°C
+2°C
(Factory default)
+3°C
+4°C
+5°C
+6°C

Power saving mode

1. Push button for at least four seconds when
the air conditioner is not working.
flashes.
Indicates CODE No. "C2."
2. Select an indoor unit to be set by pushing
side of the button).
Each time you push the button, unit numbers change as
follows:
UNIT No. UNIT No.
1-1 1-2
UNIT No.
1-4
The fan of the selected unit runs.
3. Adjust the power save setting by pushing TIME
buttons.
Each push of the button changes the power level by 1%
within the range from 100% to 50%.
* The factory default is 75%.
4. Determine the setting by pushing
5. Push button to complete the setting.
– 29 –
Installation Manual
(left
UNIT No.
1-3
Setting of power level in
power saving mode
button.