Position And Mount The Garage Door Opener - LiftMaster 8500WMC Manual Del Usuario

Abrepuertas de garaje montado en la pared
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
1

Position and Mount the Garage Door Opener

NOTE: For additional mounting options refer to the accessories page.
1.
Close the garage door completely.
2.
Slide the garage door opener onto the end of the torsion bar. If the torsion bar is too
long or damaged, you may need to cut the torsion bar.
Ensure the collar does NOT touch the bearing.
3.
Use a level to position and vertically align the garage door opener. Verify the
mounting bracket is located on a solid surface such as wood, concrete or door/flag
bracket. If installing on drywall, the mounting bracket MUST be attached to a stud.
4.
When the garage door opener is properly aligned, mark the mounting bracket holes.
If necessary, tighten collar screws on the torsion bar to hold garage door opener in
place while marking holes.
NOTE: The garage door opener does not have to be flush to wall.
5.
Remove the garage door opener from torsion bar. Drill 3/16 inch pilot holes at the
marked locations. Drill through metal door rail plates if necessary.
6.
Slide the garage door opener back onto the torsion bar until pilot holes align with
bracket.
7.
Tighten the 2 square head set screws on the torsion bar. For a hollow torsion bar,
tighten screws 3/4 - 1 full turn after making contact with the bar. For a solid shaft
torsion bar, tighten screws 1/4 - no more than 1/2 turn after making contact with
the shaft. If installing on a keyed torsion bar, DO NOT tighten the screws into the
keyway.
8.
Secure the mounting bracket to the wall and to the garage door opener. Use the
14-10 x 2" screws to secure the mounting bracket to the wall.
Shaft
Collar
.25" (.6 cm) min.
space between
bearing and
shaft collar
Bearing
Plate
Torsion Bar
Mounting Bracket
Set screws
(Torsion bar)
Screws 14-10 x 2"
9
To prevent possible SERIOUS INJURY
or DEATH:
Concrete anchors MUST be used if
mounting bracket into masonry.
NEVER try to loosen, move or
adjust garage door, springs,
cables, pulleys, brackets or their
hardware, ALL of which are under
EXTREME tension.
ALWAYS call a trained door
systems technician if garage door
binds, sticks or is out of balance.
An unbalanced garage door might
NOT reverse when required.
Garage door opener MUST be
mounted at a right angle to the
torsion bar to avoid premature
wear on the collar.
HARDWARE
Screw
14-10 x 2" (2)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

8500wmc-267

Tabla de contenido