Position The Gate Bracket - LiftMaster CSW24U Guia De Instalacion

Position the Gate Bracket

1
Slot
Pin
Measure 33 inches along the gate length from the gate hinge center. Measure 27-1/2 inches up from the concrete pad to the gate
2
bracket position on the gate as shown.
gate bracket. Use the set screws on the arm to temporarily hold the arm in place while determining the correct measurements.
3
PAS001
STEP 3
Position the operator arm onto the output shaft so that the pin slides into the slot.
Output shaft
It may be necessary to attach horizontal reinforcement to the gate before attaching the
NOTE:
33"
27-1/2"
Make sure the operator arm is level and tack weld the gate bracket in this position.
Continue to Installation Step 5 in the manual.
© 2015, LiftMaster – All Rights Reserved