Maintenance And Care; Troubleshooting - Kärcher K 5 Basic Manual Del Usuario

Storing the Appliance
Prior to extended storage periods, as dur-
ing the winter, also observe the instructions
in the Care section.
 Park the machine on an even surface.
 Push the casing of the quick coupling
for the high pressure hose toward the
rear and disconnect the high pressure
hose from the appliance.
 Press the disconnect on the trigger gun
and remove the high pressure hose
from the trigger gun.
 Stow away the mains cable, the high-
pressure hose and accessory on the
appliance.
Frost protection
Caution
Appliances and accessories that are not
completely drained can be destroyed by
frost. Completely drain appliance and ac-
cessories and protect them against frost.
To avoid damage:
 Completely drain all water from the ap-
pliance: Switch the appliance on with
detached high pressure hose and de-
tached water supply (max. 1 minute)
and wait, until no more water exits at the
high pressure connection. Turn off the
appliance.
 Store the appliance and the entire ac-
cessories in a frost free room.

Maintenance and care

Danger
Risk of electric shock. Turn off the appli-
ance and remove the mains plug prior to
performing any care and maintenance
work.
Prior to longer periods of storage, e.g. in
the winter:
Illustration
 Pull out the sieve in the water connec-
tion using flat-nose pliers and clean un-
der running water.
20
Care
The appliance is maintenance free.

Troubleshooting

You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.
Danger
Risk of electric shock. Turn off the appliance
and remove the mains plug prior to perform-
ing any care and maintenance work.
Repair work and work on the electrical
components may only be performed by an
authorised customer service.
Appliance is not running
 Pull on the lever of the trigger gun; the
device will switch on.
 Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the mains supply.
 Check the mains connection cable for
damages.
Appliance does not start, motor
Voltage reduction due to weak mains sup-
ply or when using an extension cable.
 When switching on, first pull the lever of
the hand spray gun and then switch the
appliance switch to "I/ON" or "eco".
Pressure does not build up in the
 Check setting at the spray lance.
 Check water supply for adequate deliv-
ery rate.
 Pull out the sieve in the water connec-
tion using flat-nose pliers and clean un-
der running water.
 Appliance ventilation: Switch the appli-
ance on with the high-pressure hose
detached and operate (max. 2 minutes)
until the water exits the high-pressure
connection without bubbles. Switch off
appliance and reconnect high-pressure
hose.
EN
– 11
Maintenance
hums
appliance