ENOW00945-0
CAUTION
Please inspect whether there is a loos-
ening of the clamp screw or mounting
bolts before departure.
Loosening may cause a dangerous situ-
ation, such as loss of control.
PTT type
1. To attach the outboard motor to the
boat, use the bolts to secure the out-
board motor brackets on transom
board.
1
2
1. Bolt (12 × 105)
2. Washer (small diameter)
3. Nut
4. Washer (large diameter)
351 (13.82)
327 (12.87)
163.5
163.5
Ø12.5
Ø12.5
125.5
251 (9.88)
All manuals and user guides at all-guides.com
4
3
ENOF00017-A
125.5
ENOF00018-A
ENOW00008-A
CAUTION
Mounting bolts should be installed with
the bolt head at inside surface of the
transom. Mounting bolts installed with
the threaded end at the inside surface of
the transom can cause personal injury.
Tighten the bolts sufficiency, otherwise
falling down of outboard could be hap-
pened.
ENON00003-0
Notes
1. Apply sealing agent, such as silicone
sealed between the bolts and the tran-
som board holes before tightening the
bolts.
2. Be sure to tighten the mounting bolt
nuts to the specified torque.
(30 N·m (3.0 kgf·m) 13 ft·lb)
ENOM00840-0
2. Remote control device
installation
ENOW00850-0
Remote control box location
1. Shift cable
2. Throttle cable
3. Cable harness B
Install the remote control box in a position
where it is easy to reach and operate the
controls.
Make sure there are no obstacles that can
interfere with the operation of the remote
25
INSTALLATION
5
3
1, 2
ENOF00841-0