InPro 86X0 i e Series
Verification kit with turbiglass
6. Check the measured value on the transmitter. This value (zero-point) should be recorded on
the attached sheet.
7. Carefully remove the verification kit and the adapter ring. Clean and dry the adapter ring.
Keep the adapter ring and verification kit in their case to protect them from dirt and moisture.
Store the case at room temperature.
Notice: V erification / Calibration should be done according to the appropriate instruction
manuals.
For further information, please contact your local METTLER TOLEDO representative.
InPro 86X0 i e Series
30 714 692 A
Sensor
Adapter ring
© 10 / 2021 Mettler-Toledo GmbH, CH -8902 Urdorf
en
25
Printed in Switzerland