Tabla de contenido
Publicidad
5.
Operating KPZ 71
5.1
Daily operating
Before using, please check the device for its working condition, is it ready for handling
and free of visible damages, specifically on wheels and forks.
Please check the battery and follow electronic and charger guidelines.
While handling the device not a lot of effort should require. However, if noticing any
doubts would occurred, please contact the manufacturer or dedicated dealer.
5.2
Engine warming-up
It is recommended to begin weighting after 10 minutes from the switching on the device.
5.3
Self-acting display test
After switch on the scale, automatically will begin self-acting display test. Visible
counting from 99999 to 000000. Please pay attention to all signs and symbols on the
display which are showing up on full screen, to avoid receiving an incorrect values. After
displaying zero the scale is ready to use. If scale is not showing „0" then please press
0 to resetting the scale.
5.4
Locating the load
The goods should be always placed on the pallet, on the pallet with net or in similar
containers in central point of forks.
The load cannot sticking out of the pallet. Maximum capacity cannot be overloaded.
Sudden, strong impingements can damage load cells of the scale. Avoiding strong
impingements extend longevity of load cells. To reassure long-lasting weighting values
is not recommended to leave the load on the forks for longer periods
(example: overnight), because it can influence on effectiveness load cells.
5.5
Reasons for potential incorrect weighting values:
The scale can show an incorrect weighting values when:
-
After switching on, during functional test the scale is/ or will be loaded.
-
Weighting goods are placed just right next to the control panel box, on the
ground or lean on other subjects.
-
Incorrect charging.
-
Cable connection is break down between control panel and load cells
Publicidad
Tabla de contenido
