Publicidad
Idiomas disponibles
Idiomas disponibles
2 pcs - H4 Allen Head Bolt
4 pcs - H7 Flat Washer
2 pcs - H9 Locknut
17. Install Cross Tube P7 to Front Support Tubes P9 using Allen Head Bolts H4, Flat Washers H7 and
Locknuts H9 . Use Allen Wrench T1 and Wrench T2 to tighten Bolts and Nuts.
18. Put Touch Sensor P19W into middle pocket at the back of Touch Sensor Cloth P22 and Touch Sensors
P19B into two side pockets at the back of Touch Sensor Cloth P22 as shown.
Figure 16
19. Slide Top Tubes P8 into Front Support Tubes P9 .
20. Slide Ramp Net P18 into Top Tubes P8 .
Figure 17
All Rights Reserved
© 2010 Escalade S por t s
PARTS REQUIRED:
1 pc - P7 Cross Tube
1 pc - P19W Touch Sensor
with White Connector
P22
P9
H9
H7
H7
H4
PARTS REQUIRED:
2 pcs - P8 Top Tube
P18
15
1 pc - P19B Touch Sensor
with Black Connector
1 pc - T1 Allen Wrench
P19B
P7
P8
P18
P9
For Customer Service Call 1-888-996-2729
1 pc - T2 Wrench
P19W
P19B
Aluminum surface
this side.
P9
P8
P9
Publicidad
