Remote Control - Rowenta AU56 F0 Serie Instrucciones De Uso

EN
Fan Speed Control (E)
The fan speed control has three settings: High, Medium and Low.
The choice of speed 1, 2 or 3 (
conditioner while maintaining a similar noise level: +40m3/h between each speed, which is equivalent
to an additional «cooling» of the amount of air in a room of about 16m² (room height 2.5m) in 1 hour.
Oscillation (F)
Swing Control : The SWING button moves the grille flap, evenly distributing the air into the room.
When the SWING button is pressed, the flap will begin to move forwards and backwards alternatively.
If pressed again, the flap will be locked into its current position. When the button is next pressed, the
flap will start to move forwards and backwards again.
Note: in order to avoid damaging the internal mechanisms, the flap must not be moved manually.
Note: after switching the air conditioner off, you must wait 3 minutes before switching it back.
Timer (G)
Auto turn OFF : with the machine in running mode, press the timer button. Then set the desired wor-
king time in hours before shut down by pressing the "+" or "-" buttons.
Auto turn ON: With the machine in OFF mode, press the timer button. Then set the desired time de-
lay ON in hours by pressing the "+" or "-" buttons before the unit automatically starts running in the
latest used mode.
The time is adjustable between 1 to 24hours

Remote control

The remote control uses 2 x AAA or LR03 1.5V batteries which are not included.
To change the remote's battery, remove the cover on the back of the remote controller and insert
batteries with the (+) and (-) poles pointing in the proper direction.
Remove the batteries if the remote control is not used for a month or longer.
Remote control operations are identical to the functions on the control panel. Please take care not to
scratch or damage the transmitter (LED) located on the end of the remote control as this will impair
its proper operation.
TROUBLESHOOTING
Trouble
The appliance does not start
The appliance stops running during operation
The appliance does not run and water full indi-
cator is lit
LEDs display "E1" or "E2"
) allows you to adjust the amount of air cooled by the air
Analysis
- Please wait 3 minutes and start again,
protector device may be preventing unit from
working.
- The plug is not properly plugged.
- Set temperature is too high.
- Air outlets are blocked by obstacles or hose is
obstructed.
- Air inlets (filter) are blocked by dust.
- Water needs to be drained : please refer to
paragraph "control panel – B" .
- Drainage hose is obstructed or twisted.
- Please refer to a specific Approved Service
Centre.
20
SHOULD A PROBLEM ARISE
Never dismantle the appliance yourself because R290 gas requires specific agreement for repairing.
A poorly repaired appliance may be dangerous for the user.
Do not use the appliance and contact a specific Approved Service Centre if:
• The appliance has broken.
• Unit or its power cord is damaged,
• If your appliance does not work properly.
You can find a list of specific Approved Service Centres on Rowenta website.
HELP PROTECT THE ENVIRONMENT!
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a waste collection point or an approved service centre so that it can be disposed of
correctly.
Do not throw away the batteries with your household waste : instead, bring them to anyone
of the special battery collection points.
These instructions can also be found on our internet site www.rowenta.com
21
EN