Functional Description - Makita JN3200 Manual De Instrucciones

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Permissible cutting thickness
The thickness of material to be cut depends upon the
tensile strength of the material itself. The groove on the
die holder acts as a thickness gauge for allowable cutting
thickness. Do not attempt to cut any material which will
not fit into this groove.
Max.cutting capacities
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
Switch action
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
• Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply cau-
tion when locking tool in "ON" position and maintain
firm grasp on tool.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
004776
1. Stainless steel
gauge 2.5 mm
(3/32")
2. Mild steel gauge
3.2 mm (1/8")
1
2
mm
2 3.2
2
2.5
2
1.0
2
3.5
004778
1. Lock button
1
2. Switch trigger
2
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Punch replacement
2
Fit the wrench provided onto the lock nut and tap the
handle lightly with a hammer to loosen the lock nut. Take
off the die holder and use a wrench to remove the screw.
Then remove the punch.
To install the punch, insert it into the punch holder with its
cutting edge facing forward so that the pin in the punch
006439
holder fits into the groove in the punch. Install the screw
ga
and lock nut. Then tighten them securely.
10
13
20
10
1
2
NOTE:
• When installing the screw and lock nut, be sure to
tighten securely. If they become loose during opera-
tion, the tool may break down.
2
4
5
4
004783
1. Wrench
2. Lock nut
3. Die holder
1
3
004784
1. Punch
2. Screw
3. Wrench
3
004785
1. Cutting edge
2. Punch
3. Groove
1
4. Punch holder
3
5. Pin