8. Remove the upper left hinge cover and upper left hinge from the accessory bag.
Place the refrigerated door body on the middle hinge and install the upper left hinge. Connect the refrigerator top
signal line 4 to the door body signal line 1, and connect the signal line 2 to the signal line 3.
Finally, replace the hinge decorative cover to the right side of the box body (note: when replacing the hinge
decorative cover to the right side of the box body, the two inserts on the hinge decorative cover (as shown in the
figure) shall be cut off)
(The picture above is only for reference. The actual configuration will depend on the physical product or statement
by the distributor)
2.4 Changing the Light
Any replacement or maintenance of the LED lamps is intended to be made by the manufacturer, its service agent or
similar qualified person.
2.5 Starting
2.6 Energy saving tips
● The appliance should be located in the coolest area of the room, away from heat producing appliances or heating
ducts, and out of the direct sunlight.
● Let hot foods cool to room temperature before placing in the appliance. Overloading the appliance forces the
compressor to run longer. Foods that freeze too slowly may lose quality, or spoil.
● Be sure to wrap foods properly, and wipe containers dry before placing them in the appliance. This cuts down on
frost build-up inside the appliance.
● Appliance storage bin should not be lined with aluminum foil, wax paper, or paper toweling. Liners interfere with
cold air circulation, making the appliance less efficient.
● Organize and label food to reduce door openings and extended searches. Remove as many items as needed at
one time, and close the door as soon as possible.
upper hinge
● Before initial start, keep the refrigerator still for two hours before connecting it to
power supply.
● Before putting any fresh or frozen foods, the refrigerator shall have run for 2-3
hours, or for above 4 hours in summer when the ambient temperature is high.
● Spare enough space for convenient opening of the doors and drawers or statement
by the distributor.
upper hinge cover
decorative cover
EN-10
inserts
EN