Maintenance And Care Of The Appliance; Overall Cleaning; Cleaning The Glass Shelf; Defrosting - Midea MDRB470MG Serie Manual De Usuario

4 Maintenance and care of the appliance

4.1 Overall cleaning

● Dusts behind the refrigerator and on the ground shall be timely cleaned to improve the cooling effect and energy
saving.
● Check the door gasket regularly to make sure there are no debris. Clean the door gasket with a soft cloth
dampened with soapy water or diluted detergent.
● The interior of the refrigerator should be cleaned regularly to avoid odor.
● Please turn off the power before cleaning interior, remove all foods, drinks, shelves, drawers, etc.
● Use a soft cloth or sponge to clean the inside of the refrigerator, with two tablespoons of baking soda and a quart
of warm water. Then rinse with water and wipe clean. After cleaning, open the door and let it dry naturally before
turning on the power.
● For areas that are difficult to clean in the refrigerator (such as narrow sandwiches, gaps or corners), it is
recommended to wipe them regularly with a soft rag, soft brush, etc. and when necessary, combined with some
auxiliary tools (such as thin sticks) to ensure no contaminants or bacterials accumulation in these areas.
● Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may cause odors in the interior of the
refrigerator or contaminated food.
● Clean the bottle frame, shelves and drawers with a soft cloth dampened with soapy water or diluted detergent.
Dry with a soft cloth or dry naturally.
● Wipe the outer surface of the refrigerator with a soft cloth dampened with
soapy water, detergent, etc., and then wipe dry.
● Do not use hard brushes, clean steel balls, wire brushes, abrasives (such as
toothpastes), organic solvents (such as alcohol, acetone, banana oil, etc.),
boiling water, acid or alkaline items, which may damage the fridge surface
and interior. Boiling water and organic solvents such as benzene may deform
or damage plastic parts.
● Do not rinse directly with water or other liquids during cleaning to avoid short
circuits or affect electrical insulation after immersion.
Please unplug the refrigerator for defrost and cleaning.

4.2 Cleaning the glass shelf

● Remove the drawer on the glass shelf;
● Lift up the front of glass shelf(about 60°), and then pull out;
● Remove the glass shelf and clean as needed;
● The reverse operation is for installation of glass shelf.

4.3 Defrosting

● The refrigerator is made based on the air-cooling principle and thus has automatic defrosting function. Frost
formed due to change of season or temperature may also be manually removed by disconnection of the
appliance from power supply or by wiping with a dry towel.

4.4 Out of operation

● Power failure: In case of power failure, even if it is in summer, foods inside the appliance can be kept for several
hours; during the power failure, the times of door opening shall be reduced, and no more fresh food shall be put
into the appliance.
● Long-time nonuse: The appliance shall be unplugged and then cleaned; then the doors are left open to prevent
odor.
● Moving: Before the refrigerator is moved, take all objects inside out, fix the glass partitions, vegetable holder,
freezing chamber drawers and etc. with tape, and tighten the leveling feet; close the doors and fix them with tape.
During moving, the appliance shall not be laid upside down or horizontally, or be vibrated; the inclination during
movement shall be no more than 45°.
The appliance shall run continuously once it is started. Generally, the operation of the appliance
shall not be interrupted; otherwise the service life may be impaired.
EN-19
EN