Routine Maintenance - Roborock WD1S1A Manual Del Usuario

Routine Maintenance

Product Maintenance
1. Only use official parts. Warranty services may not be available if
any unauthorized replacements are used.
2. If this product will not be used for a long time, fully charge it
and unplug it before storing it in a cool, dry place. Do not store
it where it can be exposed to direct sunlight or dampness. Fully
recharge it at least once every 3 months to avoid over-discharging
the battery.
Cleaning the Vacuum
Wipe the vacuum with a soft, dry cloth. Unplug the power supply
and ensure that the vacuum is off before cleaning.
Cleaning the Dirty Tank and Filter
1. Take out the dirty tank, lift off the cover, empty any dirty water,
then remove the filter cartridge at the bottom of the cover.
2. Remove any dirt stuck to the tank and clean the filter cartridge
with the provided maintenance brush.
3. Rinse the filter out with cold water, then shake off excess water.
4. Leave parts to dry before reinstalling them.
Notes:
• Allow up to 24 hours for filter drying. Use a second filter if necessary.
• Do not touch the filter with your hands, brushes, or sharp objects to avoid filter damage.
Cleaning the Rollers
1. Remove the vacuum from the dock, making sure to keep it switched
off. Flip out the stand and place the vacuum securely.
2. Push the Splash Guard Release and pull the cover outward to remove it.
3. Pull out the front roller using the release on the left.
* Clean weekly.
4. Pinch the left and right rear rollers with both hands, and rotate
them as shown while pulling them in the indicated direction.
015
* Clean weekly.