Checking The Spark Plug - Garland APACHE 1275 ZSL Manual De Instrucciones

English
Empty the engine oil into a suitable container so that
you can carry it to a proper clean point.
Insert the filled 0,6l of oil tube.
Wait 1 minute for the oil to completely go down to
the crankcase.
Clean the dipstick from the oil with a cloth.
Insert the rod and screw on the oil cap.
Unscrew the plug again and check the mark left by
oil on the dipstick. The mark left by the oil must be
between the minimum and maximum marks.
If the mark is below the minimum, add a little more
oil and recheck.
If the mark is above the maximum, you will have to
remove oil from the crankcase. To do this, tilt the
machine and let out a little oil (put a container at the
end of the tube to prevent oil spilling on the machine
or the ground).

8.2.3. CHECKING THE SPARK PLUG

When it comes to starting a machine, the most
common problems are produced by a dirty spark plug
or one in poor condition. Clean and check the spark
plug regularly. Check that the electrode gap is correct
(0.6 - 0.7 mm).
55/184