Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Stroller Assembly
IMPORTANT NOTE: Please refer to the end of this manual for all photos
that are referenced in parentheses in the instructions below.
Unpacking the Product
• Remove everything from the box – stroller, canopy, two rear wheels, two front wheels, parent
organizer and documents (not shown).
• Discard all packaging materials properly including plastic coverings.
• DO NOT allow children to play with any packaging materials.
I WARNING:
tools required.
Unfolding the Stroller
• Place the stroller on a level surface with the handlebar up.
• Release the safety latch by pulling the locking lever away from the frame. (1)
• Pull the handlebar upward while putting one foot on top of the stand-on platform. (2) Keep pulling
until the stroller is fully open and the latching mechanism on each side engages. Make sure to
hear an audible click. (3)
• Visually check and gently push downward on the handle to ensure that the stroller is completely
opened and locked before ANY use of the product.
I WARNING:
unfolding.
ALWAYS secure the safety latch on each side of the stroller
when it is in the unfolded use position. This will prevent collapse of
the stroller should the handlebar trigger locks be accidentally opened.
Possible pinching hazard - Be careful when unfolding the stroller.
Installing/Removing the Front Wheels
• Slide one front wheel into the front wheel housing until it clicks into place. (4) Repeat for the other
wheel.
• Pull on the wheels to ensure they are installed securely.
• To remove, press the metal release button on the back of the front wheel housing and pull away
from the stroller. (5)
Installing/Removing the Rear Wheels
• Install a rear wheel by sliding it onto the axle until it clicks into place. (6) Repeat for the other wheel.
• Pull on the wheels to ensure they are installed securely. (7)
• To remove, pull down the metal release button on the rear wheel bracket and pull the wheel from
the stroller. (8)
Installing and Operating the Canopy
• Identify the arrows on the inside of the canopy bracket. (9)
• Orient the canopy brackets so that they are pointing toward the front of the stroller and then insert
the canopy bracket posts into the frame mounts on BOTH sides. Ensure that they snap into place.
(10)
• The canopy can be adjusted forward and back.
• The canopy can also be extended by unzipping the extension zipper and pulling the canopy open.
(11)
• Rezip to close.
6
Adult assembly is required for this product. No
Keep children away from stroller while
Publicidad
Tabla de contenido
