Stroller Assembly - Joovy Zoom Manual De Instrucciones

Stroller Assembly

IMPORTANT NOTE: Please refer to the end of this manual for all photos
that are referenced in parentheses in the instructions below.
Unpacking the Product
• Remove everything from the box – stroller, front wheel, rear wheels(2), parent organizer, tire pump,
and documents (not shown).
• Discard all packaging materials properly including plastic coverings.
• DO NOT allow children to play with any packaging materials.
I WARNING:
tools required.
Unfolding the Stroller
• Keep children away from stroller while unfolding.
• Orient the stroller with the seat facing up and the handlebar closest to you.
• If necessary, release the locking latch located on the lower right side by lifting the latch off of the
catch. (1)
• Pull up on the handlebar so that the stroller unfolds to its upright and locked position.
CAUTION: While unfolding the stroller, be careful to keep your fingers from being pinched by
moving parts.
• Ensure that the stroller is completely opened and the latching mechanism is secured before ANY
further assembly or use of the stroller.
I WARNING:
when unfolding. Possible pinching hazard – Be careful when unfolding the
stroller.
Installing/Removing Rear Wheels
• Install one rear wheel by sliding it onto the axle until it clicks into place. (2)
• Repeat for other rear wheel.
• Pull on the wheels to ensure they are installed securely.
• To remove each wheel, push up the plastic tab on the rear axle and then pull the wheel outward
from the stroller. (3)
Installing/Removing the Front Wheel
Before installing the front wheel, you must lock the front forks into place. See section on "Front
Wheel Swivel Lock" below.
• Tilt the stroller backwards so that it rests on the rear wheels and the handlebar.
• Remove the plastic protectors from the front forks and discard them properly.
• Make sure the quick release lever on the wheel is in the open (unlocked) position. (4)
• Loosen the nut on the end of the front wheel axle and remove it. (5)
• Grasp the quick release lever and remove the axle from the wheel. (6)
• Insert the wheel in between the two front forks so that the axle tube aligns with the holes on both
forks and each end extends through the holes in the forks. (7)
• Grasp the quick release lever and insert the axle through one of the holes in the forks, through the
tube, and then out through the other fork. (8)
NOTE: You can insert the axle from either side of the forks.
• Ensure that the quick release lever is still in the open (unlocked) position (9), then rotate it so that it
points directly away from the fork and is aligned with the fork. (10)
6
Adult assembly is required for this product. No
ALWAYS keep children away from the stroller