Stopping The Tool; Troubleshooting; Engine; Engine Start-Up - CAMPAGNOLA GSM EL TORO Manual De Uso Y Mantenimiento

hand on the handle (16) and hold the position.
Keep the tool slightly taut and accelerate several times for a maximum of 4-6 seconds each time.
CAUTION!
• Accelerating for a long time on the same point of the branch will not further facilitate the detachment of the
fruits; change the coupling position and repeat the shaking operation.
• Make sure that the protection (18) is fully tightened.

Stopping the tool

Stop the tool by setting the on/off switch (10) to the OFF position.

5 TROUBLESHOOTING

Troubleshooting
CAUTION!
All maintenance shall be carried out by a mechanical or electric/electronic maintenance technician.
FAULT
The tool does not start.
The hook (21) detaches from the ex-
tension pole (23).
Engine (3) power decrease.
Excessive overheating of the tool
body.
Excessive oil leaking from the shaft.
CAUTION!
Failure to comply with the instructions in the manual may cause damage or injury.

6 ENGINE

Engine start-up

• See Engine manual.
CAUTION!
With the engine idle, the extension pole (23) must not move.
•
• Climatic and altimetric variations can alter the carburation.
• In case of significant engine power decrease, consult the engine manual.

Engine stop

Bring the accelerator lever (11) to the minimum and wait a few seconds for the engine to cool down.
Turn off the engine by setting the on/off switch (10) to the STOP position.

Engine running-in

See Engine manual.

Maintenance

See Engine manual.
Use and maintenance manual – Instructions
Original instructions Rev.: 00, Date 04/03/2022
CAUSE
a) There is no fuel.
b) On/off switch (10) at OFF.
c) Other causes.
Loose fixing screws (25).
Clogged or damaged air filter.
There is no oil.
Work gasket.
REMEDY
a) Fill the engine tank (13).
b) Check that the switch (10) is po-
sitioned on START.
c) See Engine manual.
Tighten the screws (25).
Clean or replace the air filter.
Top-up the oil to the
centre line of the indicator (8) by
loosening
the cap (9).
Have the gasket replaced by a
mechanical maintenance technician.
Page 29