Page 14
ENGLISH
9.1
Clogged Finger Screen
1.
If the finger screen becomes clogged with debris
causing the stream to be distorted, remove the
laminar jet assembly by unscrewing the two (2)
deck canister lid retaining screws.
2.
Remove the deck canister lid and the jet assembly
and place on the deck. Disconnect the union
located on the flexible hose attached to the bottom
of the jet assembly.
3.
Remove the finger screen from the union and
clean with a garden hose.
NOTE: Avoid damage to the nozzle opening.
After clean up, reinstall the unions.
9.2
Winterization
The laminar jet can be winterized in regions that require
winterization.
1.
Remove the deck canister lid assembly and
unscrew the ½ inch ( 13 mm) union.
2.
Thread the cap on the flexible hose attached to
the deck canister. The laminar jet can then be
replaced in the deck canister or may be removed to
a storage location. If left in the deck canister, tape
over the slot opening to ensure no water will enter
the system. If fiber optic cable is used, be sure to
remove the retaining nut on the waterproof fitting
on the bottom of the jet assembly.
Jandy
Laminar Jet | Installation and Operation Manual
®
Section 10. Parts List and
Exploded View
10.1
Key
No.
1
2
3
4
5
6
7
8
9
10
NOTE: If the electrical cord of the LED light assembly is
Parts List
Description
RGBW LED Light Engine
Assembly, Laminar Jet
Fiber Optic Assembly,
Laminar Jet
Deck Canister, Laminar Jet
Jet Assembly, Laminar Jet
(No Light Module)
Cover and Screens (5),
Laminar Jet Assembly
Mounting Brackets and
Hardware, Laminar Jet
Rebuild Kit, All Hardware,
Scratcher, Finger Screen
& Unions
Lid and Collar, Pebble,
Laminar Jet
Lid and Collar, Pewter,
Laminar Jet
Laminar Jet with RGBW LED
Light Replacement Kit
Laminar Jet with Fiber Optic
Retrofit Kit
damaged, the entire LED light engine assembly
(R0960900) must be replaced.
Order
Model
Part No.
All
R0961200
All
R0488900
All
R0489100
All
R0489200
All
R0489300
All
R0489500
All
R0490000
All
JLPBL
All
JLPWTR
All
R0960900
All
R0500300