HP DesignJet T730 Information Guide página 6

Enable email printing
Make sure that your printer is correctly connected to the Internet.
see the message, remember to check your junk email folder.
This is an optional step: If you are the printer administrator, log in at the HP
Congratulations, you now have completed Web Services setup. HP ePrint is ready to use.
For the latest information, support, and terms of use of the HP
Front-panel error messages
If you see an error message that does not appear here, and you are in doubt about the correct response, or if the
recommended action does not seem to solve the problem, try restarting the printer. If the problem remains, contact HP
Support.
Message or code
[Color] cartridge is very low on ink
Depleted cartridges must be replaced to resume printing
One or more cartridges appear to be missing or damaged
Paper jam
Paper width is smaller than the minimum size supported
by the selected paper source. Load cancelled.
Loaded paper is too wide. Manual unload required.
Paper too far from lateral load line. Please try again.
Please manually unload roll paper and try again.
Single sheet is loaded with too much skew. Press Eject to
unload paper.
The current job has been cancelled because the roll is out
of paper. Load the roll and send the job again.
You are printing a multipage job. Load another sheet to
continue printing or cancel the job.
Multi-sheet tray is out of paper. Load paper in multi-sheet
tray and press OK to continue printing or cancel the job.
End of roll has been reached. It is not possible to load the
roll.
Missing or failed printhead
4 Introductory Information
All manuals and user guides at all-guides.com
Activate your account by clicking the activation link that you will receive by email. If you don't
(http://www.hp
see http://www.h
Recommendation
Ensure that you have a new cartridge of the same color
ready.
Replace the cartridges as needed.
Insert cartridges of the correct color as needed.
See the User's Guide or follow front panel instructions.
Remove the paper and load paper of the correct size.
Remove the paper manually and load paper of the correct
size.
Remove and reload the paper.
Rewind the roll manually.
Remove and reload the paper.
Load a new roll.
Load another single sheet.
Load paper into the multi-sheet tray.
Load a new roll.
Remove and reinsert the same printhead, or try cleaning
the electrical connections. If necessary, insert a new
printhead.
Check the cartridge.