Safety Warnings Rautool X-Press1; General Safety Warnings; Tool-Specific Safety Warnings - Rehau RAUTOOL X-PRESS1 Manual De Instrucciones

SAFETY WARNINGS RAUTOOL X-PRESS1

Caution!
Read all safety warnings and assembly instructions before using the
tool
Follow these operating instructions and always keep the safety war-
nings with the tool
In addition to the operating instructions, always observe generally
applicable statutory and other binding regulations relating to the pre-
vention of and protection against accidents

General safety warnings:

1. Keep your workplace tidy and free of obstructions. Make sure there is
always sufficient light.
2. Keep children, pets and unauthorized persons away from the place at
which you are working.
3. Wear suitable work clothing. Do not wear loosely fitting clothes or jewelle-
ry. They may get caught in moving parts. Wear a hairnet if you have long
hair. Use goggles.
4. Do not touch moving parts (risk of trapping fingers).
5. Be alert. Only use the tool if you have received instructions in using it.
6. Keep your tools in a safe place. When not in use, tools should be kept in
dry, closed rooms out of the reach of children.
7. Only use the REHAU push-in jaws of the RAUBASIC system for RAUBA-
SIC joints. Do never use the tools for other purposes or systems (e.g.
RAUMULTI).
8. Only operate the tool with original REHAU parts and accessories:
9. Have servicing and repair work done only at a specialist workshop
authorized by REHAU. We reject any liability for work performed by non-
authorized personnel. The addresses of authorized service centers may
be obtained from your dealer or REHAU sales office.
All manuals and user guides at all-guides.com

Tool-specific safety warnings:

1. Keep the tool, the batteries and the charger dry and protect them from
2. Do not operate the tool in the vicinity of flammable liquids or explosive
3. Before use, examine the tool and accessories for defects (e.g. cracks on
4. Do never work with damaged tool or accessories. Send the damaged tool
5. The battery may only be charged using the charger supplied. The use
6. Make sure that the rechargeable battery contacts cannot be shortened by
7. Only use single-phase alternating current of the voltage stated on the
8. Do not insert foreign objects into the ventilation grills on the charger.
9. To prevent the motor from overheating, do not operate at maximum
10. When making joints using a REHAU tool, crimping tool and/or push-in jaw,
11. When the tool is converted (change of push-in jaws), the battery must be
Caution!
REHAU will not accept any liability for damage or injury attributable to
unsafe product use, poor maintenance or improper product or system
usage.
For planning and assembly, please use our valid Technical
Information!
You can obtain the current version of the document from your dealer
or your REHAU Sales Office, or you can download it at www.rehau.com.
moisture, extreme heat, oil and solvents. The charger is only intended for
use in dry, indoor rooms. It must not be used outdoors.
gases.
the cable insulation, oil loss of the tool, bent/defective clamping jaws,
damage or visible wear on the jaw sets etc.). Check whether the moving
parts are in proper working order, that they are not jammed and that parts
are not damaged. All parts must be correctly assembled and satisfy all of
the conditions to ensure proper tool operation.
immediately to the nearest service center.
of other types of battery or charger in conjunction with the equipment
supplied may create an explosion hazard.
metal objects, such as screws, instruments, nails etc.
power specification label.
pressure for any prolonged period. The tool is not suitable for permanent
operation. After approx. 50 consecutive clamping operations, a break of
at least 15 min. is required to allow the tool to cool down.
the due date of which is exceeded (see inspection badge) or when using
components of other systems, the warranty claim is omitted.
removed from the tool in order to avoid unintentional actuation.
17