Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Explanatory notes on the LED display on the tool
The LED in conjunction with the control electronics is used for information
about the charging condition of the battery and the tool.
SELFTEST!
When inserting the battery, the light emitting
diode display flashes several times, indicating
that the electronic control carries out its self
test successfully.
Caution! Wait approx. 30 sec between the
removal of the empty battery and the insertion
of the charged battery in order to allow the self
test to be carried out.
BATTERY
If the light emitting diode display is permanently
EMPTY!
illuminated for approx. 20 sec after an
operation, the battery is discharged and must
be recharged.
MAINTENANCE!
If the light emitting diode display flashes for
approx. 20 sec at the end of an operation,
maintenance is necessary (after 5.000
jointing). The device is to be sent to the plant
as soon as possible.
MAINTENANCE!
If the light emitting diode display is illuminated
BATTERY
for approx. 20 sec and then flashes,
EMPTY!
maintenance is necessary and at the same
time the battery is empty.
All manuals and user guides at all-guides.com
Insertion of the push-in jaw
Caution Danger of injury!
Inexpert handling of the REHAU tool may result in personal injury and/or
property damage
- Before use, check the clamping geometry of the push-in jaws for damage or
- Make sure that the lock pin is visibly snapped in with each change of the
- Prior to changing the push-in jaws, make sure to remove battery from the
Press the retaining pin of the pressing tool and rotate anti-clockwise by 30°
until the lock pin is pushed out Slide push-in jaw into the opening slot of the
tool head.
Push in the retaining pin up to the stop until the pin has snapped in.
visible wear. Damaged tools must no longer be used and must immediately
be sent to an authorized REHAU service center for repair immediately.
push-in jaw.
tool (unintentional actuation!).
21
Publicidad
Tabla de contenido
