Publicidad
Idiomas disponibles
Idiomas disponibles
support@nextlevelracing.com
SIDE VIEW
(
)
PRE-DRILLED HOLE
(
)
LEFT
(
)
PRE-DRILLED HOLE
(
)
RIGHT
15a
Install 3 x T-Nuts into the top channel and 1 x T-Nut into the side channel of the Left Pedal Arm. Repeat
the same steps for the Right Pedal Arm.
Note: For Shorter Users Please Skip
to STEP 16a & 16b.
15b
Align the through hole on the Pedal Arm with the hole on the Upright Connection Plate. Bolt through
and secure with M8 Bolt, Washer, Square Washer and Flange Nut. Repeat on the other side.
ALTERNATE PEDAL INSTALLATION
(
)
FOR SHORTER USERS
(
PRE-DRILLED HOLE
(
)
PRE-DRILLED HOLE
(
)
RIGHT
16a
Install 1 x T-Nut into the side channel of the Pedal Arm. Repeat on the other side.
18
PARTS:
TOP VIEW
• • 8 x M8 T-Nuts
PARTS:
• • 2 x M8 60mm Bolts
• • 2 x M8 Washers
• • 2 x M8 Flange Nuts
• • 2 x Square Washers
PARTS:
• • 2 x T-Nuts
)
(
)
LEFT
ALTERNATE PEDAL INSTALLATION
(
)
FOR SHORTER USERS
16b
Align the holes on the Upright Connection Plate with the T-Nut previously installed in STEP 16a. Bolt
through and secure with M8 Bolt and Washer. Repeat on the other side.
)
Note: Do not tighten the
A
Pedal Plate until the desired
position has been achieved.
17
A) Align the Large Pedal Plate with the T-Nuts previously installed in STEP 15a.
B) Bolt through and secure with M8 Bolts and Washers.
)
A
18
A) Align the Small Pedal Plate with the T-Nuts previously installed in STEP 15a.
B) Bolt through and secure using M8 Bolts and Washers.
Video Instruction: bit.ly/nlrbuild
PARTS:
Repeat
on Other
• • 2 x M8 20mm Bolts
Side
• • 2 x M8 Washers
PARTS:
)
B
• • 4 x M8 16mm Bolts
Repeat
on Other
Side
• • 4 x M8 Washers
• • 1 x Large Pedal Plate
)
PARTS:
B
• • 2 x M8 16mm Bolts
Repeat
on Other
• • 2 x M8 Washers
Side
• • 1 x Small Pedal Plate
Note: Use laser lines for
easy alignment.
19
Publicidad
