Stroller Assembly - Joovy Caboose UL Manual De Instrucciones

Stroller Assembly

IMPORTANT NOTE: Please refer to the end of this manual for all photos
that are referenced in parentheses in the instructions below.
Unpacking the Product
• Remove everything from the box – stroller, canopy, two rear wheels, two front wheel sets, tray,
parent organizer, infant car seat adapter and documents (not shown).
• Discard all packaging materials properly including plastic coverings.
• DO NOT allow children to play with any packaging materials.
I WARNING:
tools required.
Unfolding
• Keep children away from stroller while unfolding.
• Release the folding lock located on the right side by lifting the lever off of the catch. (1)
• Lift up on the handlebar of the stroller until the frame snaps into its open locked position.
CAUTION: While unfolding the stroller, be careful to keep your fingers from being pinched by
moving parts.
NOTE: Remove packing foam from rear frame assembly to ensure stroller locks in the open
position.
• Lock the safety latch. (2)
• Ensure that the safety latch is secured before ANY use of the stroller.
I WARNING:
of the stroller when it is in the unfolded use position. This will prevent
collapse of the stroller should the handlebar trigger locks be accidentally
opened. Possible pinching hazard - Be careful when unfolding the stroller.
Installing/Removing Rear Wheels
• Install one rear wheel by sliding it onto the axle until it clicks into place. (3)
• Repeat for other rear wheel.
• Pull on the wheels to ensure they are installed securely.
• To remove each wheel, push up the plastic tab on the rear axle and then pull the wheel outward
from the stroller. (4)
Installing/Removing the Front Wheels
• Place the front wheel sets onto the front wheel posts until they click in place. (5)
• Pull on the wheel sets to ensure they are installed securely.
• To remove each wheel, press down on the plastic tab in the hole at the bottom of the front wheel
and then pull the wheel outward from the stroller. (6)
Front Wheel Locks
• The front wheels can be set to swivel or lock.
• To lock the front wheels, rotate each wheel set so that it points forward.
• Pull up on the locking lever to engage the swivel lock. (7)
• To unlock the wheels (swivel mode) push down on the lever.
Installing and Operating the Canopy
• Position the canopy with the sun visor forward.
6
Adult assembly is required for this product. No
ALWAYS secure the safety latch on the side