Frequently Asked Questions - Domo DO7295S Manual De Instrucciones

Aspiradora sin bolsa
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 35
MOTOR FILTER
The motor filter is located in front of the motor. Remove the dust reservoir. Take out
the filter. Clean it thoroughly. Allow it to air-dry properly. Replace it in the vacuum.
ATTENTION
·
In a normal cleaning session, it is sufficient to tap out the filters. It is
recommended that you thoroughly clean the filters under tepid running water 3 to 4 times per year.
Make sure that it is completely dry before putting it back in the appliance. You can also replace them if
necessary. Avoid direct sunlight or intense overheating. Never put the filters in the washing appliance
to prevent deformation. Do not use abrasive or cleaning products and wash from the bottom of the
filter.
·
Make sure that all components are correctly assembled before using the vacuum cleaner again.
·
Always use the vacuum cleaner with the filters intact. If you do not do this, you may lose suction force
or damage the motor.
·
Unplug the plug before cleaning the filters.
·
Do not use a hairdryer to dry the filters.

FREQUENTLY ASKED QUESTIONS

Problem
Cause
The appliance
The appliance is not
does not start.
plugged in.
The appliance is not turned on.
The appliance
The appliance has overheated,
stops working.
so the safety was tripped. This
can be caused by dirty filters or a
blockage.
The suction is
The appliance is not correctly
too weak.
assembled, so the suction is
being lost.
The dust reservoir is full.
The hose is clogged.
The filters are dirty.
The valve on the handle of the
hose is open.
The filters are congested.
www.domo-elektro.be
Solution
Put the plug in the socket.
Press the on/off switch.
Allow the appliance to cool completely. When the
appliance has cooled down, it will function again.
Clean the filters and check that the hose is not
clogged.
Check that everything is assembled correctly.
Remove all of the accessories and then replace
them step by step in their place.
Empty the dust reservoir and make sure that it
does not exceed the maximum level.
Insert the hose in the reverse manner (with the
handle) in the suction opening of the appliance.
The clog will be suctioned to the other side,
which will free the hose.
Carefully clean the filters as described in this
manual. It is very important that you already
thoroughly clean the filters.
Close the valve.
Over time, the pores in the filters will become
congested. Replace the filters.
33
DO7295S

Publicidad

Tabla de contenido
loading

Tabla de contenido