Measuring Ac Current; Measuring Dc Current - Metrix MX 350 Manual De Instrucciones

2. Connect the red test lead to the
terminal and the black test lead to the
input terminal.
3. Apply the probe tips on the points where the
DC voltage is to be measured.
4. Read the result on the display unit
In the presence of a hazardous voltage (>30V
DC) the

Measuring AC current

1. Set the switch to
2. Open the clamp by pressing the trigger.
3. Place the clamp around the conductor to be
measured and release the trigger; check that
the clamp is correctly closed.
4. Read the measurement result on the display
unit.
For safety reasons, disconnect the measuring
leads before performing this operation. The clamp
must be positioned around a single conductor in a
circuit, with the risk of rendering the measurement
incorrect. The best measurement is obtained with
the conductor centred in the middle of the jaws.

Measuring DC current

1. Set the switch to
signal blinks on the screen.
(only MX 355)
input
22