Description Of Unit; Airless Process; Instruction Manuals List; Engine/Pump Position - Titan POWRLINER 4500 Instrucciones De Uso

PL4500
3

DESCRIPTION OF UNIT

3.1

AIRLESS PROCESS

A diaphragm pump takes in the coating material by suction and
conveys it to the tip. Pressed through the tip at a pressure of
up to a maximum of 3300 PSI (228 bar, 22.8 MPa), the coating
material is atomized. This high pressure has the effect of micro
fine atomization of the coating material.
As no air is used in this process, it is described as an AIRLESS
process.
This method of spraying has the advantages of finest
atomization, cloudless operation and a smooth, bubble-free
surface. As well as these, the advantages of high production
speed and convenience must be mentioned.
3.2

INSTRUCTION MANUALS LIST

The following is a list of the available instruction manuals for
this unit.
Online items can be downloaded at www.titantool.com
DESCRIPTION
Operation Manual
Service manual, spare parts,
accessories
3.3
ENGINE / PUMP POSITION
The engine and pump can be positioned in three
i
different places on the cart in order to shift the
weight of the unit based on personal preference.
1. If the unit has been used already, make sure the unit is not
running and has been depressurized (see section 5.5 for
pressure relief procedure).
2. Loosen and remove the four wing nuts and bolts (fig. 1,
item 1) underneath the cart that secure the engine and
pump assembly to the cart.
HOW TO FIND
• included with unit
• online
• online
1
3. Carefully slide the the engine / pump assembly to the
desired position, lining up the holes in the engine place
with the corresponding holes in the cart.
4. Replace the bolts and secure with the wing nuts. Tigthen
the wing nuts by hand.
3.4

HAND BRAKE

Be sure to engage the hand brake located behind
the right rear wheel whenever using the stencil
gun or whenever the sprayer is not in use in order
to keep it from inadvertently rolling down an
incline.
DESCRIPTION OF UNIT
Recommendations:
Standard walk-
behind position
For LazyLiner™
use, up to 200 lb.
(91 kg) operator
For LazyLiner™
use, 200-250
lb. (91-113 kg)
operator
9