Attach Spray Hose(S); Position Spray Gun(S) - Titan POWRLINER 4500 Instrucciones De Uso

SPRAY GUN SETUP
4.4

ATTACH SPRAY HOSE(S)

If you plan on using both guns, make sure
i
the shutoff valve handle for the second gun
connection (located under the dashboard) is
in the open position (handle is in line with the
valve).
If you plan on using one gun, make sure the
valve handle is in the closed position (handle is
perpendicular to the valve) and that the plug is
threaded onto the end of the valve.
ONE GUN SETUP
1. Using a wrench, thread the 50' (15m) pump hose to the
pump outlet fitting on the sprayer. Tighten securely.
2. Using a wrench, thread the other end of the 50' (15m)
airless hose to the top fitting (fig. 12, item 1) of the
manifold located underneath the dashboard.
3. Attach the 6' (2m) airless hose to the spray gun. Using two
wrenches (one on the gun and one on the hose), tighten
securely.
4. Using a wrench, thread the other end of the 6' airless
hose to the bottom fitting (2) of the manifold located
underneath the dashboard.
TWO-GUN SETUP (OPTIONAL)
1. Perform the 'One Gun Setup' steps, above for the first
spray gun.
2. Loosen and remove the cap that is attached to the second
gun connection ball valve underneath the dashboard.
3. Using a wrench, thread the 12' (4m) airless spray hose to
the second gun connection. Tighten securely.
4. Attach the 12' (3m) airless hose to the second spray gun.
Using two wrenches (one on the gun and one on the
hose), tighten securely.
14
1
2
4.5

POSITION SPRAY GUN(S)

1. Disengage the trigger cable from the tensioning clamp (1).
1
Always disengage the trigger cable from the
tensioning clamp before making any adjustments
to the spray gun position.
Attention
MODEL 2407313 (NO SMARTARM)
1. Loosen the support bar clamp (Fig. 14, item 2) and slide
the gun support bar to the desired horizontal position.
The gun should be positioned wide enough so that the
wheel will not roll through the spray pattern.
2. Loosen the gun riser clamp (3) and slide the spray gun to
the desired vertical position.
3. Reinstall the trigger cable to the tensioning clamp (1).
4. Repeat steps 1 through 3 for the second spray gun (if
applicable).
1
PL4500
3
2