Stihl FS 110 Manual De Instrucciones página 28

Blocking the Output Shaft
2
8
7
: Insert the stop pin* (7) or
screwdriver* (7) in the hole (8) in the
gearhead as far as stop – apply
slight pressure.
:
Rotate nut or cutting tool on the
shaft (2) until the stop pin slips into
position and blocks the shaft.
After mounting the cutting tool,
remove the tool used to block the
shaft.
* Comes standard with the machine or
is available as special accessory –
see "Special Accessories"
FS 110
7
Mounting the Mowing Head
Keep instruction sheet for mowing head
in a safe place.
:
Screw the
STIHL SuperCut 20-2,
STIHL AutoCut 21-2, 25-2
STIHL TrimCut 30-2,
STIHL PolyCut 20-3
counterclockwise onto the shaft (1)
as far as stop.
:
Block the output shaft.
:
Tighten down the mowing head.
Remove the tool used to block the
shaft.
1
STIHL FixCut 25-2
:
Place the mowing head on the
thrust plate (2).
Collar (arrow) must locate in the
mowing head's mounting hole
:
Push the thrust washer (3) over the
shaft (1) so that it locates against
the base.
:
Block the output shaft.
:
Screw the mounting nut (4) with the
combination wrench (5)
counterclockwise on to the output
shaft and tighten down firmly.
Remove the tool used to block the
shaft.
English / USA
5
4
3
1
2
27