Storing The Machine; Replacing The Nylon Line - Stihl FS 110 Manual De Instrucciones

Ocultar thumbs Ver también para FS 110:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English / USA
:
When the starter rope is fully
extended it must still be possible to
rotate the rotor another half turn. If
this is not the case, the spring is
overtensioned and could break.
Take one turn of rope off the rotor in
such a case.
:
Fit the starter cover on the housing.
:
Tighten down the screws firmly.
44

Storing the Machine

For periods of about 3 months or longer
:
Drain and clean the fuel tank.
:
Run engine until carburetor is dry –
this helps prevent the carburetor
diaphragms sticking together.
:
Remove, clean and inspect the
cutting tool.
:
Thoroughly clean the machine –
pay special attention to the
cylinder fins and air filter!
:
Store the machine in a dry, high or
locked location – out of the reach
of children and other unauthorized
persons.

Replacing the Nylon Line

STIHL AutoCut 21-2
Always inspect the mowing head for
signs of wear before fitting replacement
nylon line.
If there are signs of serious wear,
replace the parts concerned or
install a completely new mowing
head.
Preparing the brushcutter
:
Shut off the engine.
:
Lay your brushcutter on its back
with the mowing head facing
upward.
:
Remove the mowing head.
FS 110

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido