Stopping The Engine - Stihl FS 110 Manual De Instrucciones

: Place the unit on the ground: It must
rest securely on the engine support
and deflector.
Check that the cutting tool is not
touching the ground or any other
obstacles.
:
Make sure you have a firm footing.
:
Hold the unit with your left hand and
press it down firmly – your thumb
should be under the fan housing.
Do not stand or kneel on the drive
tube!
FS 110
: Pull the starter grip slowly with your
right hand until you feel it engage
and then give it a brisk strong pull.
Do not pull out the starter rope to full
length – it might otherwise break.
:
Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
English / USA
: Crank engine until it begins to fire.
After no more than five attempts,
turn the choke knob to e
:
continue cranking.
When the engine begins to fire:
:
Blip the throttle trigger so that the
slide control moves to the normal
run position # and the engine settles
down to idle speed.
Make sure the carburetor is
correctly adjusted – the cutting tool
must not rotate when the engine is
idling.
Your machine is now ready for
operation.

Stopping the engine

:
Move the slide control in direction of
arrow (h) to STOP-O.
At very low outside temperatures
As soon as engine runs:
:
Blip the throttle trigger to disengage
the starting throttle position. The
slide control moves to the normal
run position #
and the engine settles down to idle
speed.
:
Open the throttle slightly.
:
Warm up engine for brief period.
35