Unpacking; Description Of The Machine; Electric Cable - Lavorwash MISSISSIPPI R Instrucciones

USAGE
> UNPACKING
(see fig. D)
Take out the upper and the lower hooks, which fix
the cardboard box to the pallet, take the cardboard
box off, put two wheels of the machine on ground
and take the pallet off.
> DESCRIPTION OF THE MACHINE
(see fig. ABC)
①
Electropump switch
②
Burner switch
③
Regulator burner
④
Handle
⑤
Nozzle
⑥
Lance
⑦
Gun
⑧
High pressure hose
⑨
High pressure water outlet
⑩
Detergent tank
⑪
Diesel tank
⑫

Electric cable

⑬
Water inlet + filter
⑭
Rubber hose fitting
⑮
Pressure gauge
T.S. (if fitted)
IMPORTANT: This water cleaner is equipped
with the T.S. (Automatic Stop System), which
stops the machine during the bypass phase.
To start the water cleaner, it is therefore necessary
to set the switch on position "ON"; after that
press the pistol trigger: the Automatic Stop
System will start the machine and will stop it
automatically when the trigger is released. It
is advisable to put on the safety of the pistol
trigger whenever the machine is stopped, in
order to avoid unintentional starting.
• Any automatic start of the machine without
pressing the gun trigger is attributable to
air bubbles in the water or other similar
phenomena which do not imply the existence
of any defects in the machine.
• Do not leave the appliance unattended during
the standby for more than 5 minutes. Contrarily,
for the safety of the appliance it is necessary to
re-turn the switch into the OFF position.
• Please check that the coupling of the high
pressure hose with the appliance and the
gun supplied as standard equipments made
correctly, that is to say without any water leak.
If the appliance is equipped with a pressure
regulator:
• when the pressure is set to minimum the T.S.
may not trigger. Therefore, do not allow the
appliance to function in by-pass for more than
1 minute.
• do not act on the gun lever too frequently (this
may cause a malfunction).
> INSTALLATION AND START-UP
(fig. ⑪)
FILLING UP WITH FUEL
Fill the tank with the fuel indicated on the technical
data plate (Diesel)
Avoid that the tank is empty when the machine is
running in order not to damage the fuel pump.
• WARNING: Incorrect fuel shall not used as they as
provide hazard.
FILLING UP WITH DETERGENT
(fig. ⑩)
the detergent tank with the suggested products, su-
itable for the kind of washing to be carried out.
• WARNING: Make use only of liquid detergent, do not
absolutely use acid or too much alkaline products. We
suggest you to make use of our products, which have
been studied for the use with washer machines.
> INSTALLATION
(fig. ABC)
• Check that the master switch is turned to
"OFF" and that the water filter is fitted into
the pump's inlet pipe.
• Screw the snap connection into place by hand,
without the aid of tools.
• Connect the water supply hose to the snap
connection. The hose must have an inside
diameter of at least 13 mm (1/2").
• Connect the high pressure hose to the pump's
outlet pipe. Press the high pressure hose
EN
21