Safety Instructions - Dell 1100MP Guía De Información Del Producto

All manuals and user guides at all-guides.com

Safety Instructions

CAUTION:
Use the following safety guidelines to help protect your projector from
potential damage and to ensure your own personal safety:
• The surface beneath the projector might be hot with use. Be careful in handling the
unit.
• The lamp becomes very hot with use. Do not attempt to replace the lamp after use
until the projector has been allowed to cool down for at least 30 minutes, and
follow all instructions in "Changing the Lamp."
• Do not touch the bulb or the lamp glass at any time. The bulb may explode due to
improper handling, including the touching of the bulb or the lamp glass.
• Remove lens cap before turning on projector. Failure to do so may cause the lens
cap to reach high temperatures.
• To avoid damaging the projector and lamp, allow the cooling fan to run for 2
minutes before turning off the projector.
• Do not block the ventilation slots and openings on the projector.
• Disconnect the power cord from the electrical outlet if the projector is not used for
a long period of time.
• Do not use the projector in an extremely hot, cold, or humid environment.
• Do not use the projector in areas susceptible to excessive dust and dirt.
• Do not use the projector near any appliance that generates a strong magnetic field.
• Do not place the projector in direct sunlight.
• Do not look into the lens while the projector is on; the bright light may hurt your
eyes.
• To reduce the risk of fire or electric shock, do not expose the projector to rain or
moisture.
• To prevent electric shock, do not open or disassemble the projector further than
what is needed for lamp replacement.
• To avoid damaging the projector, ensure that the zoom lens and elevator foot are
fully retracted before moving the projector or placing the projector in its carrying
case.
• Turn off the projector and disconnect it from the electrical outlet before cleaning it.
Use a soft cloth moistened with mild detergent to clean the display housing. Do not
use abrasive cleaners, waxes, or solvents.
• To reduce the risk of fire from the intense light emitted by the lens, do not put any
object in front of or near the lens during operation.
Product Information Guide 5