Safety: Lamp Disposal; Regulatory Notices; Federal Communications Commission (Fcc) Notice (U.S. Only) - Dell 1100MP Guía De Información Del Producto

SAFETY: Lamp Disposal

THE LAMP(S) INSIDE THIS PRODUCT CONTAIN(S)
MERCURY AND MUST BE RECYCLED OR DISPOSED OF
ACCORDING TO LOCAL, STATE, OR FEDERAL LAWS. FOR MORE
INFORMATION, CONTACT THE ELECTRONIC INDUSTRIES
ALLIANCE AT WWW.EIAE.ORG.

Regulatory Notices

Federal Communications Commission (FCC) Notice (U.S. Only)

CAUTION:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference.
• This device must accept any interference received including interference that may
cause undesired operation.
Instructions to Users: This equipment complies with the requirements of FCC (Federal
Communication Commission) equipment provided that the following conditions are met.
1.
Power cable: Shielded power cable must be used.
2.
Video inputs: The input signal amplitude must not exceed the specified level.
NOTICE:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
6 Product Information Guide
All manuals and user guides at all-guides.com