Publicidad
Idiomas disponibles
Idiomas disponibles
Centering the camera horizontally
Immediately thereafter, one vertically centered green bar will be
projected onto the screen, together with a text box. The text box
indicates "CAMERA ALIGNMENT HORIZONTAL" with a symmetri-
cal scale bar (from -50 to +50) under the text.
If the indicated value below the bar scale is not equal to zero (i.e. the
black highlight is not in the middle of the bar scale), the camera is not
centered horizontally. Follow the steps below to center the camera
horizontally:
K
use a screwdriver to turn the screw situated on the upper-right
corner of the camera clockwise or counter clockwise until the the
scale bar indicates zero;
K
press ENTER to continue to centering the camera vertically.
Centering the camera vertically
One horizontally centered green bar will be projected onto the screen,
together with a text box. The text box indicates "CAMERA ALIGN-
MENT VERTICAL" with a symmetrical scale bar (from -50 to +50)
under the text.
If the indicated value below the scale bar is not equal to zero (i.e. the
black highlight is not in the middle of the bar scale), the camera is not
centered vertically. Follow the steps below to center the camera
vertically :
K
use a screwdriver to turn the screw situated on the lower-left
corner of the camera clockwise or counter clockwise until the
highlight is in the middle of the scale bar (value below the bar scale
becomes zero).
After finishing the vertical centering, press ENTER to return to the
IRIS SETUP menu.
Set Touch-up options
A touch up of the convergence; horizontal and vertical shfit, can be
done when selecting a source or after a preprogrammed time.
Touch-up on source means every time when switching from one
source to another, the static convergence will be re-adjusted auto-
matically.
Touch-up on timer means when the user-preprogrammed time is
reached, the static convergence will be re-adjusted automatically.
For convergence purpose, the screen is divided into 25 adjustment
areas. Every area has its unique number from 1 to 25. Touch-up
adjusts only area 1. This adjustment is also called the "static conver-
gence".
2
5975477 IRIS
211196
On-screen operating instructions
Screw for centering the
camera horizontally
Screw for centering
the camera vertically
23
25
24
22
5
4
20
18
21
19
CAMERA
ALIGNMENT
HORIZONTAL
+00
CA MERA
ALI G NME N T
VERTICAL
+00
9
15
17
8
14
16
1
2
3
6
10
12
7
11
13
7
Publicidad
Capítulos
