Maintenance; Identifying Damages - Zummo Z1 Manual De Usuario

7.2. MAINTENANCE

Exterior machine maintenance: simply requires daily cleaning.
Interior of the machine: After every 50,000 cycles, the inner machine guides and springs must be
lubricated and a full cleaning carried out.
Periodically lubricate the paddle shaft. (Fig. 15). Always use a lubricant approved for use with food
products.

7.3. IDENTIFYING DAMAGES

Damage
The display is not lit
The display shows
message Error
The display shows
message Error and a
flashing Icon.
Blocked machine
Breakage of guide plate
Not enough juice is
being extracted from the
fruit
The second half of the
orange turns around
The orange rebounds in
the cup and misses the
blade
Oranges pop out from
the paddle
For any advice or to request spare parts, you should state the model and serial number
Cause and/or solution
No power supply.
Fuse burnt out. (Fig. 11)
Power cable not properly connected.
Switch power on. (Fig. 6)
Damp in circuit board. Supply dry heat to the board.
Cover badly fitted. (Fig. 16)
Filter tray out of place. (Fig.17)
Upper protective device badly fitted. (Fig. 18)
Bin badly fitted. (Fig. 19)
Motor overheating.
See section 9.
Check to see if the oranges being squeezed are frozen.
Check to see if peel has built up in the juicer tray.
Check to see if the ball has not been properly screwed in.
Check to see if peel has become stuck inside the cup.
Check that you haven't fitted different sizes of cup and ball.
The skin of the fruit may be too thick. Remove the washer from
underneath the ball.
To unblock the machine, use the 3mm Allen key to the right of the lower
grille of the machine. Insert it into the hole on the right-hand side and, with
the machine unplugged, turn it in a clockwise direction until you can raise
the cup and release the blockage. IMPORTANT: before plugging in the
machine, make sure you have removed the key from its fitting.
The Peel Extracting Bands are loose or broken and peel is piling up in the
Juicer tray.
The nut of the cup is not tight enough.
The ball in the squeezer tray is loose.
The skin of the fruit is too thin. Check that the washer is fitted underneath
the ball; fit a maximum of one washer.
Orange may be too small for the cup and ball set being used. Fit the
medium set, or the cup with the elastic accessory.
Check the size of the oranges in the calibrator.
Orange may be too large for the cup and ball set being used. Fit the large
set with the elastic accessory.
Check the size of the oranges in the calibrator.
The paddle shaft is too dry; proceed to grease it. (Fig. 15)
of your machine (Fig. 5).
31