Kyocera KM-C830D Manual De Operaciones página 17

3. Troubleshooting
Display message
Warning low memory
WARNING LOW MEMORY
Warning image adapt
WARNING IMAGE ADAPT
Print Overrun Press GO
PRINT OVERRUN PRESS GO
Memory Overflow Press GO
MEMORY OVERFLOW PRESS GO
Virtual Mailbox Full
VIRTUAL MAILBOX FULL
Interface occupied
INTERFACE OCCUPIED
Opt. ROM error Press GO
OPT. ROM ERROR PRESS GO
Format error Hard Disk
FORMAT ERROR HARD DISK
Check chad box
CHECK CHAD BOX
Face-Up Tray Path Error
FACEUP TRAY PATH ERROR
12
All manuals and user guides at all-guides.com
There is not enough memory. You can check how much printer memory there is by printing
out a status page. Delete any unnecessary font data and macros.
Because there is not enough memory, printing cannot be performed at the set resolution.
Either add more memory to the printer or change the resolution.
A data overrun error has occurred due to insufficient memory.
• Use the M and N keys to move the arrow e until it points to the desired command and
then press the Enter key.
GO: Continues printing.
CANCEL: Cancels the printing operation completely.
• If "Auto Continue" is turned "On", the printing operation will be restarted automatically after
the amount of time specified there.
• Once this error message is displayed, "Page Protect" will be turned "On" automatically.
The current print job could not be completed due to insufficient memory in the printer.
• Use the M and N keys to move the arrow e until it points to the desired command and
then press the Enter key.
GO: Continues printing. The data that has already been processed will be printed out and
the remaining portion of the print job will be printed onto the following page.
CANCEL: Cancels the printing operation completely.
• If you are using a RAM disk, reduce the size of the RAM disk. If this error occurs often, it is
recommended that you install additional memory into the printer. For more detailed
information on adding memory, contact your service representative or an authorized
service center.
• If "Auto Continue" is turned "On", the printing operation will be restarted automatically after
the amount of time specified there.
There is not enough area in the virtual mailbox. Print out data in the virtual mailbox.
The selected interface is currently is use. Wait for a while and then attempt the operation
again.
A write error has occurred in the optional ROM. Use the M and N keys to select the "On"
command and then press the Enter key. The error state will be erased.
Initialize the hard disk.
Either the punch waste box is not correctly installed or it is full. Reposition or empty it as
necessary.
The side tray is closed. Printing is not possible. Open the side tray.
Procedure