Publicidad
Idiomas disponibles
Idiomas disponibles
ISO DIN radio provision with pocket
1. A ttach the (4) white panel clips to the radio
housing. (Figure A)
2. Attach the pocket to the radio brackets using (4)
#8 x 3/8" Phillips screws provided with this kit.
(Figure B)
3. Remove the metal "DIN" sleeve and trim ring
from the aftermarket radio.
4. Attach the radio brackets to the radio using the
screws supplied with the radio. (Figure C)
5. Locate the factory wiring harness and antenna
connector in the dash, and complete all necessary
connections to the radio. Metra recommends
using the proper mating adapter from Metra and/
or AXXESS.
6. Reconnect the negative battery terminal and test
the aftermarket radio for proper operation.
7. Mount the radio assembly into the dash using
the factory screws and slip the radio trim panel,
provided with this kit, onto the radio face.
8. Reassemble the dash in the reverse order of the
dash disassembly to complete the installation.
KIT ASSEMBLY
(Figure A)
(Figure B)
(Figure C)
REV. 2/2/22 INST99-6532B
3
Publicidad
