Dexter 20VRPS2-180.1 Manual De Instrucciones página 74

FR
B. GENERAL CUTTING
ES
Mark the line of the cut clearly. Press the power switch to start the cutting action. Set
DO NOT FORCE. Use only enough pressure to keep the saw cutting. Allow the blade and saw to do the work.
PT
C. PLUNGE CUTTING
Clearly mark the line of cut. From a convenient starting point within the cut out area, place the tip of the blade over that point with the saw parallel
IT
to the line of cut. Slowing lower the saw until the button edge of the shoe rests on the workpiece. Slowly start the saw and allow it to reach full
speed.With the saw resting on the shoe, slowly lower the blade onto the cut line. Continue this motion until the saw blade is perpendicular to
the workpiece.
EL
WARNING : Make sure the blade doesn't touch the workpiece until the saw reaches its max speed.
Failure to comply could cause loss of control and result in serious injury.
PL
D. METAL CUTTING
When cutting metallic material with this tool, be sure to use a sharp blade designed for this purpose. We recommend lubricating the cutting surface
UA
with cutting oil to avoid heat buildup. Follow the general cutting procedure on the previous page. Do not force tools. Use only enough pressure to
keep the saw cutting. Blade for metal cutting is available in store.
RO
E. TRANSPORTATION CONDITIONS
Transportation of products can be any kind of closed transport in the packaging of the manufacture or without it, preserving the product from
mechanical damage, precipitation, exposure to chemically active substances and compliance with precautionary measures for the transport of
EN
fragile goods.
10. MAINTENANCE
WARNING :
They contain chemicals that can damage, weaken or destroy the housing, thus compromising the integrity of of the double insulation.
A. GENERAL
WARNING : Always remove the battery pack from the tool before carrying out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls free of dust. Occasionally you may see sparks through the ventilation slots. This is normal
and will not damage your power tool.
Replace the saw blade according to which material to cut, as soon as its teeth are blunt and proper sawing is therefore no longer possible. Clean
the appliance after completing your sawing work. Remove any dirt (e.g sawdust). If necessary, clean the saw blade mounting with a brush or
blow it out with compressed air.
The ambient temperature range for tool and battery use and storage is 0ºC /+45ºC.
The recommended ambient temperature range for the charging system during charging is 0ºC /+40ºC.
There are some user serviceable parts in your power tool. Please refer to the list of spare part list of the manual.
B. INSPECTING THE MOUNTING SCREWS
Regularly inspect all mounting screws and ensure that they are properly tightened. Should any of the screws be loose, tighten them immediately.
Failure to do so could result in serious injuries
C. MAINTENANCE OF THE MOTOR
The motor unit winding is the very "heart" of the power tool. Exercise due care to ensure the winding does not become damaged and /or wet with
oil or water.
d in a vice or with clamps to the workbench or table.
74