Install The High Pressure Hose; Connect The Water Supply To The Machine - GreenWorks Pro PW60L00 Manual Del Usuario

EN
8.3 INSTALL THE HIGH PRESSURE
HOSE
11
1. Push one end of the high pressure hose (11) into the inlet
coupler (13).
2. Before installing the included high pressure hose (11),
thread the priming valve onto the pressure washer outlet
and rotate clockwise until tightened.
3. Once installed, thread one end of the included high
pressure hose and tighten onto the valve.
• Small amounts of water exiting the valve as pressure
washer priming valve is normal. This is needed to bleed
the system from air.
8.4 CONNECT THE WATER SUPPLY
TO THE MACHINE
The machine works only when there is water in the bucket or
the base is connected with a water supply. When there is no
water connected, push the power switch to stop the machine.
8.4.1 CONNECT THE WATER SUPPLY TO
THE MACHINE
• The water supply must come from the water main
• Do not use hot water
• Do not use water from ponds or lakes
Follow local regulations when you connect the garden hose
to the water supply. Direct connection through a receiver
tank or backflow preventer is usually permitted.
Inspect the filter in the water inlet connector before you
connect the garden hose
• If the filter is damaged, do not use the machine until the
filter is replaced.
• If the filter is dirty, clean the filter.
13
11
WARNING
WARNING
WARNING
CAUTION
English
16
1. Uncoil the garden hose (15) (not included).
2. Thread adapter (12) to the male garden hose (15).
3. Pull back the adaptor collar and attach to the male
connector (16) on the machine.
4. Turn the water supply off.
5. Let the water flow through the garden hose (15) for 30
seconds.
There must be a minimum of 10 feet of free hose between
the water inlet and the water supply.
8.4.2 INSTALL THE BUCKET
1. Add water to the bucket (4).
4
2. Align the water inlet connector (17) with the water inlet
(16).
17
3. Install the bucket (4) onto the base.
8
15
CAUTION
16
12