Presentation; Safety Regulations; Receiver Control - Autoadapt Carony Classic Modo De Empleo

EN
The contents of these instructions
must be read and understood before
the product is taken into use. Keep the
instructions easily accessible for further
reference. The Carony system consists of
a swivel base mounted in the vehicle and
a wheelchair wheel unit. The system has
in its basic design been safety tested. If
the system is altered or rebuilt for other
purpuses than intended, Autoadapt AB
denies any liability.

1. Presentation

Carony is a transport wheelchair that makes it
possible for the person assisting to move a pas-
senger from the wheelchair wheel unit to the ve-
hicle without lifting. The wheelchair can be height
adjusted to enable the docking of the seat onto
the swivel base in the vehicle. When the seat has
been transferred to the swivel base, the wheel
unit is disconnected and the seat swivelled inside
the vehicle.

2. Safety regulations

Carony is tested and approved for a maximum load of 100 kg.
To improve security it is recommended that the Carony is equipped
with tilt protection.
The brake system shall only be used as a parking brake, and not for
braking the wheelchair in motion.
It is important never to leave the passenger in the wheelchair without
applying the parking brakes.
The wheelchair should not be used in slopes where the person driving
it risks to loose control.

3. Receiver control

Unpack the wheelchair and make sure that Carony was not damaged during transport.
Mount the necessary accessories.
Adjust armrests, headrest, footrests and backrest (see following headline).
For security reasons and for practise, please try out all the functions before use.
10
All manuals and user guides at all-guides.com
Autoadapt AB
Certifies that the product: Carony
Fulfils following demands according to conditions in:
74/60/EEC including 2000/4
74/408/EEC including 2005/39,2006/96
78/932/EEC
93/42/EEC, 2007/47/EEC,
LVFS 2003:11
95/28/EEC
ECE R-17
ECE R-21
ECE R-25
EN 12182
EN 12183:2009
ISO 3795
ISO 8191-1
ISO 8191-2
ISO 7176:1-19
ISO 10542
Stenkullen 2012-01-01
DECLARATION OF CONFORMITY