Testing The Controls; Testing Saw Chain Lubrication - Stihl MSA 120 C Manual De Instrucciones

English

19.2 Testing the Controls

Before starting work, confirm that the trigger switch
lockout (1) and the trigger switch (2) are undamaged and
functioning properly.
Trigger Switch Lockout (1) and Trigger Switch (2)
WARNING
To reduce the risk of serious or fatal injuries, keep hands,
feet and other parts of the body away from the saw chain. Do
not touch the saw chain while the battery is inserted. Never
touch moving saw chain with your hand or any part of your
body, @ 6.5.2. Keep bystanders out of the area while
testing the controls.
To test the controls:
► Remove the battery.
► Attempt to depress the trigger switch.
If the trigger switch can be depressed without first
depressing the trigger switch lockout, take the chain saw
to an authorized STIHL servicing dealer to be repaired
before use.
46
1
2
► Insert the battery and hold the chain saw firmly with both
hands, your left hand on the front handle and your right
hand on the rear handle. Release the chain brake and
switch on the chain saw by depressing the trigger switch
lockout and trigger switch.
If the chain does not start rotating, engage the chain brake
and remove the battery. Take the chain saw to an
authorized STIHL servicing dealer to be repaired before
use.
► Insert the battery and hold the chain saw firmly with both
hands, your left hand on the front handle and your right
hand on the rear handle. Release the chain brake and
switch on the chain saw by depressing the trigger switch
lockout and trigger switch. Then release the trigger switch.
If the saw chain does not stop rotating after you release
the trigger switch, engage the chain brake and remove the
battery. Take the chain saw to an authorized STIHL
servicing dealer to be repaired before use.

19.3 Testing Saw Chain Lubrication

WARNING
Never operate your saw without bar and chain lubrication. If
the chain runs dry, the cutting attachment will be damaged
beyond repair within a very short time. A damaged chain
may break, resulting in severe or fatal personal injury.
Always check chain lubrication and the oil level in the tank
before starting work and periodically during work.
To confirm that the chain lubrication oil is flowing properly:
► Insert the battery, @ 17.1.
► Disengage the chain brake, @ 16.2.
► Point the guide bar toward a bright surface.
► Switch on the chain saw, @ 18.1.
The saw chain should throw off a small amount of oil.
If the chain lubrication oil cannot be seen, check the oil
tank for chain lubrication oil.
Refill the tank as necessary.
► Test the saw chain lubrication again.
19 Checking the Chain Saw
0458-716-8621-D