DeWalt DWE46150 Manual De Instrucciones página 7

,_ WARNING: This attachment MUST BE used with a dust extractor
system. ALWAYS wear certified safety face or dust mask.
NOTE: Ensure hose connection is secure.
NOTE: The amount of dust retained by the dust extractor vacuum
is dependent on its filter system. Refer to the dust extractor vacuum
instruction manual for more information.
All DEWALT dust collection shrouds are designed to work with the
DEWALT universal DWV9000 connector.
1. Attach the DWV9000 connector (L) to your dust collector hose (K).
2. Unlock the DWV9000 connector (L) and slide onto dust port (A).
3. Lock the DWV9000 connector (L) to secure.
TRADITIONAL DUST EXTRACTOR VACUUM HOSES
Attach recommended dust extractor vacuum hose to dust port (A).
OPERATION
_WARNING: To reduce the risk of injury, ALWAYS turn off
tool and disconnect the tool from the power source before
making any adjustments or removing or installing attachments
or accessories. This applies to both the grinder and the dust
extractor vacuum. Such preventative safety measures reduce the
risk of starting the tool accidentally.
A WARNING: For your own safety, read the instruction manual for
both the grinding tool and the dust extractor vacuum before using any
accessory. Failure to heed these warnings may result in personal injury
and serious damage to the tool and the accessory. When servicing this
tool, use only identical replacement parts.
NOTE: The amount of dust retained by the dust extractor vacuum
is dependent on its filter system. Refer to the dust extractor vacuum
instruction manual for more information.
1. Ensure all assembly instructions have been completed.
2. Turn the dust extractor vacuum on as instructed in the dust
extractor vacuum instruction manual.
3. Turn the tool on as instructed in the tool instruction manual and
allow it to reach full speed before making contact with work
surface.
4. Place the surface grinding shroud to flat work surface such as a
floor or wall and begin grinding.
5. When surface grinding is complete, turn the tool off and disconnect
from the power source. Allow the tool to stop rotating before laying
it down.
NOTE: The surface grinding shroud and dust extractor vacuum will
only be effective when used with a diamond surface cup wheel on a
flat surface.