DeWalt DWE46150 Manual De Instrucciones página 8

Edging Use Application (Fig. 1)
This concrete grinding shroud has a door feature to allow flush
grinding against a wall.
1. Turn off the tool and disconnect from the power source.
2. Using the edging door tab (C), rotate the edging door until it snaps
into the open postion.
3. Connect the tool to the power source.
4. Position hands and body away from wheel and door opening.
5. Place the door edge flush to work surface, turn the tool on and
begin grinding. Remove the tool from work surface before turning
the tool off.
7. When flush grinding is complete, turn off the tool and disconnect
from power source. Allow the tool to stop rotating before laying it
down.
8. Using the edging door tab (C), rotate door until it snaps into the
closed position.
MAINTENANCE
,&WARNING." To reduce the risk of injury, ALWAYS turn off
tool and disconnect the tool from the power source before
making any adjustments or removing or installing attachments
or accessories. This applies to both the grinder and the dust
extractor vacuum. Such preventative safety measures reduce the
risk of starting the tool accidentally,
Replace Brush Skirt (Fig. 1)
1. Turn off the tool and disconnect from power source.
2. Push worn brush skirt from brush skirt removal holes (D).
3. Press new brush skirt into brush skirt removal holes until secure.
Replacement brush skirts are available at extra cost from your local
dealer or authorized service center. If you need assistance in locating
any accessory, please contact DEWALT Industrial Tool Co., 701 East
Joppa Road, Baltimore, MD 21286, call 1-800-4-DEWALT (1-800-
433-9258) or visit our website: www.dewalt.com.
Cleaning
_, WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
,& WARNING: Never use solvents or other harsh chemicals for cleaning
the non-metallic parts of the tool These chemicals may weaken the
plastic materials used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the tool," never
immerse any part of the tool into a liquid.
Accessories
A WARNING: Since accessories, other than those offered by DEWALT,
have not been tested with this product, use of such accessories with
this tool could be hazardous. Toreduce the risk of injury, only DEWALT
recommended accessories should be used with this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact DEWALT
Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, call
1-800-4-DEWALT (1-800-433-9258) or visit our website: www.dewalt.
com.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (including brush inspection and replacement) should be
performed by a DEWALT factory service center, a DEWALT authorized
service center or other qualified service personnel. Always use
identical replacement parts.