Clearing Foil Jams; Cleaning And Servicing - Olympia A 180 Manual De Instrucciones

4 Remove the protective foil from the foil pocket.
5 Insert the document to be laminated in the foil pocket so that there is a
margin of approx. 3 - 5 mm to the edge of the foil on all sides.
6 Insert the foil pocket containing the document in the laminator's inser-
tion slot. Insert the ready closed side of the foil in first.
Note: To prevent the laminating foil from creasing, never feed the
open side of the laminating pocket first in the insertion slot of the lami-
nator. When inserting the foil pocket, observe the instructions on the
insertion slot. The laminating process occurs automatically.

Clearing Foil Jams

The laminator is provided with the "Jam Release" function in order to clear
foil jams quickly.
1 If the foil jams, switch the unit off and actuate the Release switch on
the rear of the unit, to the right.
2 Hold the laminator firmly and pull the foil pocket together with the
document to be laminated out of the laminator's insertion slot.
3 It will probably be necessary to then clean the unit several times as
described in the Section "Cleaning and Servicing".
4 If foil jams occur repeatedly or jammed foil cannot be removed from
the laminator, please contact our hotline (refer to Guarantee).

Cleaning and Servicing

Deposits and residual adhesive on the transport rollers can influence the re-
sults of the laminating process. Therefore, the transport rollers must be
cleaned periodically after use:
To do this, insert a folded piece of paper in the insertion slot. Residual adhe-
sive is removed and taken up by the paper when ejected. Repeat the proc-
ess several times.
Disconnect the power plug before starting to clean the unit with a damp
cloth. If necessary, the housing can be cleaned using a cloth moistened with
clean water with a little mild soap applied. Never use any solvents or ag-
gressive cleaning agents.
All manuals and user guides at all-guides.com
15