Troubleshooting - Oster FPSTJE4000R Manual De Instrucciones

PROBLEM
The appliance does not work.
The hopper does not open.
The juicer stops during
normal operation.
There are fine lines or scratch
marks on the product.
Juice leaks over the base.
The chamber shakes
during operation.
TR O U BL E S HOOT ING
• Make sure the power cord is properly plugged in.
• Check if the hopper is assembled properly. If the hopper
has not been locked into place, the appliance will not
operate for safety reasons.
• Check if the appliance has been assembled according to
the directions given in this manual.
• Refer to the assembly instructions in this manual.
• Is there lot of pulp left inside the chamber? Press the on
"I" button to expel excess pulp.
• Have foreign substances or solid objects such as hard
seeds been left in the juicer?
• Press the reverse " " button to bring the foreign objects
back up toward the hopper chute. Unplug the juicer before
removing them.
• DO NOT attempt to open the hopper by force. If the issue
is not resolved after following the above procedures, take
unit to the nearest authorized Oster
• Have you put heavy loads or large pieces of ingredients
into the appliance?
• Read the section " WHEN THE AUGER STOPS DURING
OPERATION (REVERSE/" " BUTTON)" of the manual
and follow guidelines for using the reverse " " button.
• If the issue is not resolved after following the above
process, take it to the nearest authorized Oster
service center.
• These are molding marks resulting from the normal
manufacturing process. This is normal and does not
affect use.
• Has the extraction seal been inserted properly?
• Juice could leak out when the extraction seal is loose or
has not been inserted properly. Push the extraction seal
all the way into the pulp outlet for a tight seal.
• If juice is still leaking even with the extraction seal inserted
correctly, overloading may be the problem. If the chamber
is overloaded with ingredients, the extraction seal may
be pushed out of position, allowing the juice to leak out
through the gap. Always juice small, manageable amounts
of ingredients at a time and avoid processing heavy loads.
• Slight shaking may be caused by the motor.
• Depending on the texture of the ingredients, there may be
slight to more pronounced shaking of the appliance.
• There is some level of shaking when the auger is rotating.
This is normal and not a malfunction.
• Hard ingredients (e.g., carrots, potatoes, radishes, beets,
etc.) may cause more shaking than soft ingredients.
En g lish -15
SOLUTION
service center.
®
®